Hi,
Have created an issue with my van It no longer starts.
Van is a 1991 2.4D (AAB). No immobiliser.
I was trying to fix my lack of working reversing lights (fuse blows when ignition turned on). I found quite a lot of exposed, broken and near broken cabling in my loom, around the areas where it leaves the protective sleeves (some Y junctions there too).
What I have done -
- insulated cables that had exposed copper.
- replaced length of cable for oil pressure sensors as it was exposed and looked close to breaking.
- replaced section of a think black cable. no idea what it was for, but it looked like it was about to fall apart. What is it?
- replaced broken sections of black/thin red and back/thin blue (which I think are reversing light cables)
- replaced broken cable to the water pump that does it's thing after the engine is turned off.
Now the van won't start. Turns over, but won't fire. Doesn't sound like it is trying to fire. I replaced the glow plug relay, but same result.
Any thoughts on what I have broken? The engine started before I started work on it.
(also, I still have no reversing lights!)
Thanks,
dan
Have created an issue with my van It no longer starts.
Van is a 1991 2.4D (AAB). No immobiliser.
I was trying to fix my lack of working reversing lights (fuse blows when ignition turned on). I found quite a lot of exposed, broken and near broken cabling in my loom, around the areas where it leaves the protective sleeves (some Y junctions there too).
What I have done -
- insulated cables that had exposed copper.
- replaced length of cable for oil pressure sensors as it was exposed and looked close to breaking.
- replaced section of a think black cable. no idea what it was for, but it looked like it was about to fall apart. What is it?
- replaced broken sections of black/thin red and back/thin blue (which I think are reversing light cables)
- replaced broken cable to the water pump that does it's thing after the engine is turned off.
Now the van won't start. Turns over, but won't fire. Doesn't sound like it is trying to fire. I replaced the glow plug relay, but same result.
Any thoughts on what I have broken? The engine started before I started work on it.
(also, I still have no reversing lights!)
Thanks,
dan
Comment