Hey everyone...
My rear wipers are not working :-( Have checked fuse and all is good there.
Am in the process of insulating the bus so a double question if I may.
On taking the panel off the rear door to inspect the wiper motor I found a black wire connected to well, nothing actually, and cannot see anything that it may connect to :-( Noticed that there are two black wires attached to a kind of pcb(?) but only one is connected back to the motor.
Any suggestions?
Also, how has everyone insulated the back door? It is all small holes and alike and I don't really want to be using expanding foam and wallmate covering wiring etc. Was thinking about just a silvered bubble wrap type solution attached to the panel as the 'simplest' solution though not the most efficient I would guess.
Thanks in advance guys and gals
My rear wipers are not working :-( Have checked fuse and all is good there.
Am in the process of insulating the bus so a double question if I may.
On taking the panel off the rear door to inspect the wiper motor I found a black wire connected to well, nothing actually, and cannot see anything that it may connect to :-( Noticed that there are two black wires attached to a kind of pcb(?) but only one is connected back to the motor.
Any suggestions?
Also, how has everyone insulated the back door? It is all small holes and alike and I don't really want to be using expanding foam and wallmate covering wiring etc. Was thinking about just a silvered bubble wrap type solution attached to the panel as the 'simplest' solution though not the most efficient I would guess.
Thanks in advance guys and gals
Comment