Laptop stolen from missus
Gearbox photos uploaded again
Some work on the intake
Chain drilled and butchered
Tidied up
Best Tig welding yet. Started in the middle, lower section is pulled and shite, top bit was pushed and much better, not good but better.
plate going on to blank off original flange mounting
ran out of gas, it was getting late and couldnt be bothered to change cylinder so left it there and tidied it up a bit
Started to hack up a bit of old scrap with the new dewalt battery grinder, could be new favourite tool, not going in the tool thread cos its dirty and used now.
My £1 ebay vice still going strong - another good buy, felt bad turning up at the blokes house and giving him a quid.
And this is what is going on the chain drilled bit, MAP sensor and intake flange that was relocated from other end
Beauty.
Gearbox photos uploaded again
Some work on the intake
Chain drilled and butchered
Tidied up
Best Tig welding yet. Started in the middle, lower section is pulled and shite, top bit was pushed and much better, not good but better.
plate going on to blank off original flange mounting
ran out of gas, it was getting late and couldnt be bothered to change cylinder so left it there and tidied it up a bit
Started to hack up a bit of old scrap with the new dewalt battery grinder, could be new favourite tool, not going in the tool thread cos its dirty and used now.
My £1 ebay vice still going strong - another good buy, felt bad turning up at the blokes house and giving him a quid.
And this is what is going on the chain drilled bit, MAP sensor and intake flange that was relocated from other end
Beauty.
Comment