Originally posted by Thebigredone
View Post
Announcement
Collapse
No announcement yet.
Finally starting the conversion
Collapse
X
-
Originally posted by Eagles02 View Postwell done mate,getting the kids on board to reel in another victim erm I mean enthusiast.Van looks the shizzle.
Sell my T4 !!! I'd rather stick wasps up my butt.
Comment
-
Originally posted by Thebigredone View PostI've just noticed we have the same oven lol mines white tho ! Need to give it a test run to see if it's any good.
Sell my T4 !!! I'd rather stick wasps up my butt.
Sent from my iPhone using Just T4s
Comment
-
Originally posted by t4moneypit View PostWe need to swap then if you’ve got a white one, we cooked two Chicago town pizzas in ours and they only took about 10 minutes more than a conventional oven so I was quite impressed although it does get bloody hot
Sent from my iPhone using Just T4s
Sell my T4 !!! I'd rather stick wasps up my butt.
Comment
-
Originally posted by Thebigredone View PostGot the table finished at last, that diner feel is coming along, were happy with how it's going, Just wanna get out in it again now [emoji2]
Sell my T4 !!! I'd rather stick wasps up my butt.
Also, sent you a PM, is you’re inbox full..!
Sent from my iPhone using Just T4s
Comment
-
Had to do the clutch just before lockdown, it was slipping like mad, stripped it all down thinking the plate was toast but it was fine.
Looked in the bell housing and all became apparent !!!
The pivot pin had lost its nylon cap and over time the metal on metal just punched a hole in the release arm, the spring that keeps the arm on the pivot pin had also broke and the release arm was getting stuck with the clutch half engaged, hence the slipping.
Anyway looked to getting some replacement parts ordered, I already had the clutch kit and slave cylinder.
I couldn't find anywhere to get a pivot pin from unless I went on Ebay and had one sent from Greece or USA (postage was more than the part)
Found a kit on Darkside Devolpments that had all the parts I needed for £60 delivered, while I was at it I changed upper ball joints and drivers outer cv joint, the old bus is back to good health again for now !!
Sent from my SM-G965F using Just T4s
Comment
Comment