Well I’ve had the van a few weeks, progress a little slow, but having fun!
Cleared out all the ply and previous insulation, so looking a little bare.
Fairly productive today. Managed to get the cab floor out despite all the sikoflex! So lots of scraping and white spirit. It was particularly bad at the rear edge and under the heel pad areas. A bit more cleaning to do then I’ll cover with some thin insulation before refitting the cab mat. Not much rust which was good, apart from a few spots around the seat bolts which will get treated as well.
Tackled a few electrical gremlins with the ignition switch feed to the radio, so will fit a new switch next. Managed to get the old one out, bit fiddly with the tiny screw hidden away by the steering column but hopefully the new one will go back in ok!
The roof lining was changed by the previous owner and is pretty good, but the interior light doesn’t fit the hole?.. anyone know what I could replace the standard light with? The hole is about 75 x 90mm.
Still loads to do!!
Sent from my iPad using Just T4s
Cleared out all the ply and previous insulation, so looking a little bare.
Fairly productive today. Managed to get the cab floor out despite all the sikoflex! So lots of scraping and white spirit. It was particularly bad at the rear edge and under the heel pad areas. A bit more cleaning to do then I’ll cover with some thin insulation before refitting the cab mat. Not much rust which was good, apart from a few spots around the seat bolts which will get treated as well.
Tackled a few electrical gremlins with the ignition switch feed to the radio, so will fit a new switch next. Managed to get the old one out, bit fiddly with the tiny screw hidden away by the steering column but hopefully the new one will go back in ok!
The roof lining was changed by the previous owner and is pretty good, but the interior light doesn’t fit the hole?.. anyone know what I could replace the standard light with? The hole is about 75 x 90mm.
Still loads to do!!
Sent from my iPad using Just T4s
Comment