Announcement
Collapse
No announcement yet.
Big Blue
Collapse
X
-
There is then a cable that connects both bulbs to each other with a power cable running of to whatever source you connect for the DRL part to Work (with inline fuse).
Tom.
Comment
-
Originally posted by Sirfbum View PostYou and be both mate! I think you pull out the existing bulb holders and grommet from the indicator. The new bulb has grommet built in so goes in its place. Then it connects to the old bulb holder inside the engine bay (via a transformer for each light).
There is then a cable that connects both bulbs to each other with a power cable running of to whatever source you connect for the DRL part to Work (with inline fuse).
Tom.
🇬🇧 Home Is Where You Park It.
Comment
-
-
Originally posted by Sirfbum View PostYou and be both mate! I think you pull out the existing bulb holders and grommet from the indicator. The new bulb has grommet built in so goes in its place. Then it connects to the old bulb holder inside the engine bay (via a transformer for each light).
There is then a cable that connects both bulbs to each other with a power cable running of to whatever source you connect for the DRL part to Work (with inline fuse).
Tom.
Cheers.
Sent from my iPhone using Just T4s
Comment
-
Big Blue
Originally posted by Jonnybigballs85 View PostTom, they are not transformers mate but loading resistors .....
.....The gold resistors will get warm when used.....
.....I would suggest maybe screw them to the chassis somewhere to help dissipate the heat.......
.....If you get a minute can you please see how well they fit In the back of the indicators??
[/url]
So just did a quick fit and test on indicator only mode (not wired in the DRL part).
Easy fit- the bulb just pushes in the back of the indicator lense and seals ok. Only gripe is that the end of the new bulb more or less touches the front of the indicator lense.
Then you connect to the original bulb socket. Just tucked all the gubbings inside and stuck the hazards on- works and is brighter than the other side:
After running for about 30 seconds the resistors were quite warm, bordering on hot- so as Mr BigBalls says, will have to be careful mounting them. Could mount where they are here (just up a little bit) but will poke around- want to make sure they are away from anything plastic or wires etc!
Tom.Last edited by Sirfbum; 7 October 2017, 01:54 PM.
Comment
-
Originally posted by robbie#t4 View PostYes Tom! Looking great!
I might get a set of these too!
I did a drl/turn mod on the drl head lights! Just like an audi now [emoji12]
Sent from my iPhone using Just T4s
Sent from my iPhone using Just T4s
Comment
Comment