If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Picking up hi build primer today so they’ll be in primer later. Pics no probs at all. Just so you know I’m doing this with cans not a gun. I use proper stuff from a paint store and so long as you get the prep correct I can get just as good finish as I can when I use a paint gun!
Feeling slightly inspired to refurb the alloys that I took off my van to fit my steelies. Even if to sell on! They look properly shyte at the moment!!!
Feeling slightly inspired to refurb the alloys that I took off my van to fit my steelies. Even if to sell on! They look properly shyte at the moment!!!
Tom
Mate honestly if you’re half way competent it’s easy. It’s all in the prep. Steady away. If you can see problems in the prep it won’t look any better when the paint goes on!
Mate honestly if you’re half way competent it’s easy. It’s all in the prep. Steady away. If you can see problems in the prep it won’t look any better when the paint goes on!
Mate honestly if you’re half way competent it’s easy. It’s all in the prep. Steady away. If you can see problems in the prep it won’t look any better when the paint goes on!
Iv been looking at my alloys in the garage , ordered some paint today just to play but I also rang a place near me last week that does powder coating . Ideally I’d like them like this and done professionally .... but in the mean time I’m just Gona experiment.
Comment