None Start

[Activ8]

Damn - didn't even think of that.

Yeh right.... of course you didn't.[emoji6]

[Greeny gtc]

[ATTACH=CONFIG]13342[/ATTACH] This came back today from its holiday in Devon. I half expected it to be engraved with a cock. Hope to find time to swap it back on over the weekend. Mind its 25 years since we jumped the broom stick on Saturday so Henry may get a bit of a bashing.

Shite that is getting sooo close for the boss and me [emoji54]

Sent from my SM-G960F using Just T4s

[AndyLeach]

[ATTACH=CONFIG]13342[/ATTACH] This came back today from its holiday in Devon. I half expected it to be engraved with a cock. Hope to find time to swap it back on over the weekend. Mind its 25 years since we jumped the broom stick on Saturday so Henry may get a bit of a bashing.

Happy Silver Anniversarie for the weekend [emoji1317]🤙🏽[emoji1317]


T4ism is not a Dis-easeJust T4s

[regcheeseman]

[ATTACH=CONFIG]13342[/ATTACH] I half expected it to be engraved with a cock.

Damn - didn't even think of that.

[S49]

This came back today from its holiday in Devon. I half expected it to be engraved with a cock. Hope to find time to swap it back on over the weekend. Mind its 25 years since we jumped the broom stick on Saturday so Henry may get a bit of a bashing.

[S49]

I'll do it the way you recommend. Printed off the guide you kindly sent to the old chaps email. Very informative, must of flicked though it ten times already.

[regcheeseman]

I'd do it by the method above and ear - but if you want to go DTI that's fine as well.

Turn your boost up as well

[S49]

Oh and of course a massive thank you. So 0.95 on the DTI? its a long time since that's been out the box.

[S49]

Its finished already? Yep that's dads address Spout House.. Do you want "Paypalling"? That will be a new one for me. PM me the cost and details.

[regcheeseman]

Oh - when I put the pulley back on the nearest I got was 0.89mm lift with the locking pin in and 1.05mm with the slop taken out of the locking pin. Ideally you probably want it somewhere between the two.
So if you time it up with the crank mark a gnats cock away from the gearbox mark (BTDC) - we are talking about 1mm and don't preload the pump pulley like I normally tell everyone to do, you should be fine.

And you'll need my setup guide.

[regcheeseman]

Cheers. Ouch is that cog supposed to be in 2 parts? At least it got there.

Nope.

All fixed now.

I've booked on 48hr return to sprout house - hope that's right. The £200 insured return courier was 19.80

[S49]

Cheers. Ouch is that cog supposed to be in 2 parts? At least it got there.

[regcheeseman]

Bit of a mess



Don't worry I have spares.

[AndyLeach]

Many a cockwomble has had a fuckstick piss rope [emoji23]


T4ism is not a Dis-easeJust T4s

[arfur fox-acre]

Go piss up a rope, fuckstick.

Finally a response.....now I feel complete.
Normal service is resumed.