If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Cheers guys, panels on order !!! Yeah it was a fair dollop of expanding foam but didn’t understand why it was in there as there wasn’t any filler over it !!
Cheers guys, panels on order !!! Yeah it was a fair dollop of expanding foam but didn’t understand why it was in there as there wasn’t any filler over it !!
Sent from my iPhone using Tapatalk
Might be worth some further investigation... very odd....
I think it is, there's a load of stuff from the other place thst was applied to mine when I got it, epanding foam allnover the place being one of them. Don't think it was in the cills though.
I think it is, there's a load of stuff from the other place thst was applied to mine when I got it, epanding foam allnover the place being one of them. Don't think it was in the cills though.
I’ll keep you all up to date , I’ve been reading up on the servo issues so hoping I’ve diagnosed it correctly. All of my brakes were binding to varying degrees but as soon as the servo pipe was pulled the brakes released. Reconnected pipes and within 2 pumps the brakes would barely move. If you pull the brake pedal up with your foot this also released the brakes. Checked a few other threads and general consensus is that if you don’t have a leaky pipe then it’s likely to be the servo
Comment